Well, I spoke too soon about Replicraft's second axle assembly. The first assembly went back because the axle support plates were welded on at the wrong angle which made the two rear "V" legs have a measurement of 28" apart. The front legs were at 24" apart which is correct. Should have checked the angle of the axle support plates on the second assembly before I spent $55.00 to have the axle shaft turned down to 1.25. AGAIN!! The OD of the "raw" piece of tubing is 1.257, which is just enough to keep the wheel bearings of the Cleveland 5X5's from sliding on the axle! So-----After removing the second set of "V's" from the clamps,( sanded, shaped, and drilled) I mounted them on the axle assembly and found that the two rear "V" legs were still 28" apart!!! I CHECKED AND DOUBLE CHECKED! Steve at Replicraft said he modified his welding jig to correct this problem but the axle assembly is still wrong! If you would like to see this new assembly, go to http://community.webtv.net/smlangford/FlyBabylandinggear Let me know what you thank about this assembly. Back to the drawing board------ "Steze" http://community.webtv.net/smlangford/StevesFlyBaby